IKO Ridge Vent Installation Nationwide

IKO Ridge Vent Installation: The West Covina Owner’s Guide

IKO ridge vent installation in West Covina typically runs $18 to $26 per linear foot installed, including the vent material, fasteners, and labor, so a standard 40-foot ridge lands between $720 and $1,040. We stock IKO’s full line of ridge vents on our trucks and can usually complete a full ridge vent replacement in a single visit. Most homeowners discover a problem because they notice heat buildup upstairs, peeling shingles near the peak, or visible damage to the vent cap after a Santa Ana wind event. If your attic feels like an oven in August and your AC runs non-stop, the ridge vent is the first place to look.

Call (831) 777-6412

Which IKO Models This Applies To

IKO makes three ridge vent lines you’re likely to encounter on West Covina roofs: the Armourvent Multi (a rigid, shingle-over vent that disappears into the roofline), the Armourvent Standard (a lower-profile version for steeper pitches), and the Ultra HP (a high-capacity roll vent for larger attic spaces). The fastest way to identify yours is the thickness where it sits under the cap shingles: the Multi runs about 12 inches wide with a raised profile, the Standard is closer to 11 inches and sits flatter. If the original label is long gone and the vent is crumbling, measure the width at the narrowest break and match it to the replacement, not to what the neighbor down the street has.

OEM IKO vents are still manufactured and readily available through our suppliers, so in most cases there’s no reason to substitute an aftermarket brand. The one exception we make is when a roof has been re-shingled at some point and the original IKO vent was replaced with a GAF Cobra or Owens Corning VentSure, which are both quality products we also stock. What matters is that the replacement matches the existing cut line and that the net free air volume is adequate for the attic square footage. We’ll verify that before we write a quote.

We’re an independent roofing company in West Covina, not affiliated with IKO, but we’ve installed their ridge vent systems on hundreds of homes across the San Gabriel Valley, from the tract developments off Amar Road to the custom builds above Galster Wilderness Park.

Signs Your IKO Ridge Vent Installation Is Failing

• Shingle granules collecting in the gutters directly below the ridge. This means the cap shingles over the vent are degrading faster than the field shingles, usually because the original install used thin cap stock or the vent wasn’t centered on the ridge cut. West Covina’s summer heat accelerates granule loss on exposed caps, and the ridge is always the first casualty.
• Visible cracks, splits, or collapse in the vent material itself. The Armourvent Multi is made of a rigid plastic that becomes brittle after 10 to 15 years under Southern California sun. When it cracks, it’s done. No amount of caulk fixes a fractured ridge vent.
• A noticeable second-story temperature spike in summer even with the AC running. A failed ridge vent stops pulling hot air from the attic, and that heat radiates through the ceiling. If the upstairs bedrooms are 10 to 15 degrees hotter than the rest of the house, the attic ventilation is likely compromised.
• Lifted or missing sections after a significant wind event. The Santa Ana winds that whip through West Covina can catch a poorly fastened ridge vent and peel sections away from the roof deck. If you can see daylight or gaps under the cap shingles from the curb, that’s failed install or aged fasteners.
• Moisture staining on the underside of roof sheathing near the peak. A compromised ridge vent allows rain to blow in during winter storms, and that moisture condenses on the sheathing. Mold near the ridge line is a sign the vent has been failing for a while. It’s usually caught during a re-roof, and it’s never good news.

Replacement Cost & What’s Included

A full IKO ridge vent replacement in West Covina runs $18 to $26 per linear foot installed. Every job includes removing the old vent and cap shingles, inspecting the existing ridge cut for width and straightness, installing the new IKO vent, and re-capping with matching IKO cap shingles. If the roof is older and a color match is difficult, we carry current IKO cap stock in the most common West Covina colors, and we’ll get as close as possible before we start. The cost difference between a basic replace-in-kind job and a higher-price install comes down to roof pitch (anything over 8/12 runs higher due to safety equipment and pace), attic air sealing work, and whether the existing cut needs to be widened for proper airflow. You get the written price before we start, and the 365-Day Done Right Promise covers the work for a full year, in writing, included.

DIY or Call Us?

Here’s the honest split. You can safely check the obvious stuff from the ground or with a ladder against the gutter: look for cracked vent sections, lifted cap shingles, and uneven ridge lines. What you shouldn’t do is walk a ridge on a hot roof in West Covina and attempt to remove cap shingles over the peak. Ridge work combines steep angles, heat-softened shingles, and a risk of blowing right through an old vent that’s already compromised. We’ve seen plenty of homeowners get a foot through a rotted section with no idea it was there. That’s a call to us anyway, plus a bigger repair. If the vent looks failed, call us at (831) 777-6412 and we’ll get a written quote out before you spend a minute on a ladder.

FAQs